Setting guidelines on the rear
view image
CAUTION
!
When adjusting the guidelines, be sure to
park the vehicle in a safe place and apply the
handbrake.
!
Before getting out of the car to place the
markings, be sure to turn the ignition switch
off (ACC OFF).
!
The range projected by the rear view camera
is limited. Also, the vehicle width and distance
guidelines displayed on the rear view camera
image may differ from the actual vehicle
width and distance. (The guidelines are
straight lines.)
!
The image quality may deteriorate depending
on the usage environment, such as at night or
in dark surroundings.
1
Park your vehicle in a safe place and
apply the handbrake.
2
Using packing tape or similar, place
markings approximately 25 cm from each
side of the vehicle, and approximately
50 cm and 2 m from the rear bumper.
Rear bumper
25cm
50cm
25cm
2m
Markings
Markings
3
Put the gearstick in reverse and display
the rear view camera screen.
4
Touch
.
The screen for setting the guidelines appears.
5
Touch
or
.
The screen for adjusting the points appears.
#
If you touch [
Clear
], the display position of the
guidelines returns to the factory settings.
6
Touch
or
to select a point.
7
Touch
,
,
or
to adjust
the position of the point.
The setting range for each point is shown
below.
!
Lower left:
63,
663,
221,
181
!
Upper left:
221,
517,
75,
339
!
Upper right:
581,
157,
75,
339
!
Lower right:
699,
27,
221,
181
p
When a point is moved, the distance the
point is moved from the initial value is dis-
played at the top right of the screen.
8
Touch [OK].
The set value is saved and the rear view image
appears.
#
If you touch [
Clear
], the point returns to the
position prior to adjustment.
#
If you touch
, the display returns to the set-
ting screen for guidelines without reflecting the
setting.
Engb
151
Chapter
27
Customising
pr
eferences
Customising preferences
