Pinnacle Spas LUXURY DX 5000, Owner'S Manual

Page: 47 / 70

Page 45
For HELP, call 800.304.9684
PROBLEM CAUSE SOLUTION
work Loose wire Check wiring harness to LED
Loose plug Reseat J20 plug on hot tub pack
Low/no jet Air lock Bleed air from the system (page Error!
Bookmark not defined. )
pressure Dirty filter Check and clean or replace filter
Closed jets Open all jets by turning CCW
Closed valves Open all T-handle shutoff valves on
heater and pumps
ACV open Close air control valves
Low water Fill hot tub 1” above all jets
Moved my
hot tub and Wiring error
at GFCI Check Neutral wiring of GFCI (see
diagrams on pages 10-20)
now it
doesn’t work
No power to
hot tub Reset circuit breakers on GFCI panel
and main circuit breaker panel
Nothing
works Breaker has
tripped Check and reset breaker. If problem
persists, check for loose electrical
connections. Check for Neutral wiring
error at GFCI.
Fuse blown Check for blown Fuse 4 (F4) inside of
spa pack.
Pump not
running No power to
hot tub Reset circuit breakers on GFCI panel
and main circuit breaker panel
Water does Air lock Bleed air from the system (page Error!
Bookmark not defined. )
not flow
Closed jets Open all jets by turning
counterclockwise
ACV open Close air control valves
Water too
hot High set
temperature Turn down set temperature on topside
control panel
High ambient
temperature Remove the cover
Water will
not heat Thermostat is
set too low Check and reset to desired temperature
Air open Close air control valve
Dirty filter Check and clean filter
Blown fuse Check and replace fuse
Slide valve
closed Check and open all valves
Cover off Put the cover back on
Hot tub in
Economy
mode Press the Standby button and take out
of Economy (see
Economy Mode on
pages 28)