Pinnacle Spas LUXURY DX 5000, Owner'S Manual

Page: 31 / 70

Page 29
For HELP, call 800.304.9684
Mode
Your hot tub operating mode is changed by first pressing the “WARM” or “COLD”
button, then pressing the “MODE” button (in the LX 8000, LX 9000 and LX 11000
– and LX 4000 and LX 5000 export) or the “LIGHT” button (in the LX 4000 and
LX/DX 5000).

Standard Mode is programmed to constantly maintain the desired
temperature. “ Std ” (or “ St ” in the LX 4000 and LX/DX 5000) will be
displayed momentarily when you switch into standard mode.

Economy Mode heats the spa to the set temperature only during filter
cycles. “ Ecn ” (or “ Ec ”) will display solid when temperature is not current
and will alternate with temperature when temperature is current.

Sleep Mode heats the hot tub to within 20°F/10°C of the set
temperature only during filter cycles. “ SLP ” (or “ SL ”) will display solid
when temperature is not current and will alternate with temperature
when temperature is current.
Preset Filter Cycles
The first filter cycle begins six minutes after the hot tub is energized. The second
filter cycle begins 12 hours later. Filter duration is programmable for 2, 4, 6 or 8
hours – or for continuous filtration indicated by “
FI LC ” (or “ FC ”). The default filter
time is two hours.
To program filter cycles, press “WARM” or “COOL” and then “JETS.” Press
“WARM” or “COOL” again to adjust to your desired setting. Press “JETS” again
to exit filter cycle programming.
The low speed of the 2-speed pump runs during filtration and the ozonator will be
enabled.
Smart Winter Mode
If the system (sensor located inside heater) detects ambient conditions
below 44ºF/6.7ºC, it automatically enters the Smart Winter Mode for
period of four minutes after it detects the hot tub temperature has risen
to 45ºF/7.2ºC.