Pinnacle Spas LUXURY DX 5000, Owner'S Manual

Page: 24 / 70

Page 22
For HELP, call 800.304.9684
Before Adding Water
Before adding water, go through these simple steps now to prevent
common issues when setting up your
hot tub for the first time. Verify that
the following have all been rechecked.
1. Turn off all power to the hot tub at the main breaker panel.
2. Open the side panels to access the internal components.
3. Check that all slide valves are opened
(T-handles pulled out) to the heater and
all pumps.
4. Check that there are no obvious signs of
loose wires or broken pipes.
Figure 16 - Valve Open/Closed
5. Check that the two heater unions
are hand tight.
Caution: Do not use a wrench.
Over-tightening may
cause damage to unions
and gaskets, which will
not be covered under
warranty.
Figure 17 - Unions Tight
6. Check that the unions on all pumps are tight.
7. Clean out any foreign debris from within the service access area or
inside of the hot tub itself.
8. With the drain open and filters removed, thoroughly rinse out the hot
tub with warm water until the drained water runs clear. Run water
through the filtration canister and jet lines to remove any incidental
dust, dirt, and debris that may have accumulated during shipment or
installation. Drain all water completely.
9. Make sure that the hot tub drain valve is closed and the cap is on
tight (see page 50).
10. Install the filter(s) in the filtration canister.
11. Check that all of the
hot tub jets are open (turned full counter-
clockwise).
12. Now is the best time to clean and polish the surfaces of your hot tub
(see pages 44).