Pinnacle Spas LUXURY DX 5000, Owner'S Manual

Page: 32 / 70

Page 30
For HELP, call 800.304.9684
Startup Procedure for all PN Models
Figure 22 (K450 Topside Control)
1. Go to the topside control panel and look at the display. The spa first
goes through a startup sequence after which pump 1 high, pump 2 (if
equipped) will run for a one minute purge cycle. Pump 1 (low) will then
start in filtration cycle.
2. Press the Jets 1 button. You should hear the two-speed pump turn on at
high speed, see water circulating, and see the Jets icon illuminated on
the panel.
Caution: If water is not flowing from the hydrotherapy jets after 2
minutes, turn the power off at the main panel and bleed the air from the
system (see page 43). Turn the power on again. Sometimes
momentarily turning the pump off/on will help prime the pump. Do this
no more than three times.
3. If the water is running smoothly through the lines, open the seat(s)
manifold air control valves and you should see an increase in jet
pressure. Check and adjust the water and airflow of every jet if
necessary.
Each direction hydrotherapy jet in your spa can be adjusted for
massage intensity and directional flow. Pivot the angle of a jet to
achieve an optimal massage.
Adding air mixture intensifies the level of your massage. Turn the
seat(s) manifold air control valves counterclockwise to increase the air
mixture and clockwise to turn it off.
To minimize heat losses, close all seat(s) manifold air control valves
when your spa is not in use.