Pinnacle Spas LUXURY DX 5000, Owner'S Manual

Page: 30 / 70

Page 28
For HELP, call 800.304.9684
Warm/Cool Buttons (LX 8000, LX 9000 and LX 11000) (Set
Temperatures between 80°F - 104°F / 26°C - 40°C)
The startup temperature is set at 100°F/37°C. The last measured temperature is
constantly displayed on the LCD and is current only when the pump has been
running for at least two minutes. To
display the set temperature, press the
“WARM” or “COOL” button once. To change the set temperature, press the
“WARM” or “COOL” button a second time before the LCD stops flashing. Each
press of the “WARM” or “COOL” button will continue to raise/lower the set
temperature. After three seconds, the LCD will stop flashing and display the
current hot tub temperature.
Temp Button (LX 4000 and LX/DX 5000) (Set Temperatures between
80°F - 104°F / 26°C - 40°C)
To display the set temperature, press the “TEMP” button once. To change the set
temperature, press the “TEMP” button a second time. Before the LCD stops
flashing, continue to press the “TEMP” button to raise/lower the set temperature.
If the opposite direction is desired, release the “TEMP” button and let the screen
revert to the current water temperature. Press the “TEMP” button to display the
set temperature and again to make the temperature change in the desired
direction.
Jets 1 and Jets 2 Buttons
Press the “JETS 1” button once to activate the low speed of Pump 1. Press it a
second time to activate the high speed of Pump 1. Press it a third time to turn off
Pump 1. If left running, the high speed of Pump 1 automatically will turn off after
15 minutes and the low speed of Pump 1 automatically will turn off after 4 hours.
The low speed of Pump 1 runs when the “JETS 2” Pump 2 is on. It may also
active for at least two minutes every half hour to detect the hot tub temperature
and then to heat to the set temperature if needed (depending on mode). When
the low speed turns on automatically, it cannot be deactivated from the panel,
however the high speed may be activated.
Press JETS 2 once to activate Pump 2. Press it again to turn off Pump 2.
Aux Button
Press the “AUX” button once to turn on the Air Jet Bubbler (blower). Press it a
second time to turn off the Air Jet Bubbler. If left running, the
Air Jet Bubbler
automatically will turn off after 15 minutes.
Light
Press the “LIGHT” button once to turn on your hot tub lights. Press the LIGHT
button multiple times to cycle through the many available color patterns. Press
the LIGHT button again to turn off the LED light system. If left on, the lights
automatically turn off after 4 hours.