Pinnacle Spas LUXURY DX 5000, Owner'S Manual

Page: 40 / 70

Page 38
For HELP, call 800.304.9684
Input Current, Phase Setting for PN Models
These options are accessible by keeping the Light key pressed for 20
seconds. At this point the Input current will displayed. Press Up or Down key
to select 10 to 48A current set. (Default setting for US/Canada is 40A). Press
Light key again to validate a setting.
*For European spas only. After Light key pressed for 20 seconds Number
phases parameter will displayed. Press Up or Down key to select 1 or 2
phase application. (Default setting is 1 phase). Press Light key again to
validate a setting.
Press Light key again. At this point Input current will be displayed.
Press Up or Down key to select 16-20 A for dual phases or 10-40A for single
phase. (Default setting is 16A for dual phases and 32A for single phase).
Press Light key again to validate setting.
Ozone generator (if equipped) will oxidize contaminants present in the water
and run with P1 (low) in Filter cycle only. Ozone generator will turn off if there
is any user demand for pumps, blower or light and remains off 40 minutes
after last user demand.
Filtration, Sanitation for PN Models
The spa water filtration is provided by the low speed of the 2-speed pump.
This pump moves the water through the filter cartridge allowing surface dirt to
be skimmed. The low speed pump 1 Filter cycle default setting is 2 hours,
twice per day. (See programming procedure for details).
Each filter cycle occurs in two steps:
1. Purging Step.
a. In Purge step (clean all plumbing lines) all pumps are turned
on at high speed for short time (60 seconds).
2. Cleaning Step.
a. Pump 1, low speed runs by filter cycle setting.
Ozone generator runs with low speed pump 1.
Setting the Water Temp for PN Models
Use the up / down keys to set the water temperature you desire. The
temperature setting displays for five seconds to confirm your new selection. The
set point icon indicates that the display shows the desired temperature (not the
actual water temperature). The default temperature setting is 95ºF.