Pinnacle Spas LUXURY DX 5000, Owner'S Manual

Page: 46 / 70

Page 44
For HELP, call 800.304.9684
How should I clean my hot tub?
Use non-sudsing cleaners and non-oily polishes (see page 51). Our All
Purpose Cleaner quickly removes scum lines and helps restore your
shell’s original beauty. Rinse all filters, covers, pillows, and surfaces
thoroughly with warm tap water. Our Filter Cleanser is a safe, effective
way to clean and re-use your filters and our Plumbing Cleanser cleans
the inside of all plumbing in your hot tub. Call 800.304.9684 to order
these easy-to-use cleaning products.
Where can I get more Chemicals or other accessories?
Visit www.hottubparts.com or call 800.304.9684.
T r o u b l e s h o o t i n g
If a problem arises, you can check this list for a quick solution. If this
does not resolve your problem, please call our customer care center, at
800.304.9684. Additional information is also available at
www.PinnacleSpas.com. You will need your serial number to access this
site.
Important – Most problems can be quickly resolved by resetting
the GFCI breaker. Try this first before proceeding.
PROBLEM CAUSE SOLUTION
Breaker trips Wiring error Load Neutral wire not connected to
GFCI (connected to Neutral bus)
Wrong GFCI GFCI breaker is wrong size
Ozonator (or
blower) wet Remove tube from ozonator (or blower)
and allow 2 days to dry out
Foamy water Soaps, skin
oils, or
undissolved
sanitizer
particles Close the air control valves and allow
filtration cycle to run
Add defoamer
Drain and clean your hot tub
Clean or change filters
Rinse all bathing suits before bathing
Leak Loose
connection Check and hand-tighten unions at
heater & pumps, or clamps on jets
Drain open Close drain valve or replace cap
Light
doesn’t
LED
burnt out Replace bulb