Philips Respironics V60, User Manual

Page: 156 / 212

A-4
First-time installation
Installing the battery
WARNING: Installation or replacement of lithium batteries by inadequately trained
personnel could result in a hazard.
WARNING: To reduce the risk of fire, explosion, leakage, or other hazard, take these
precautions with respect to the battery:
- Do not attempt to disassemble, open, drop, crush, bend or deform,
insert foreign objects into, puncture, or shred the battery pack; modify
or remanufacture it; immerse or expose it to water or other liquids;
expose it to fire, excessive heat (including soldering irons); or put it in
a microwave oven.
- Replace the battery only with another battery specified by the
manufacturer.
- Follow all instructions for proper use of the battery.
- Do not short-circuit the battery or allow metallic or conductive objects
to contact the battery connector housing.
- Use the battery with the Respironics V60/V60 Plus Ventilator only.
Install the battery as follows (Figure A-3).
1. Shut down and then unplug the ventilator.
NOTE: Failure to properly shut down the ventilator before battery installation
may result in erroneous alarms after power-on.
2. Remove the side panel by turning the captive fastener a ¼ turn and
releasing.
3. Using a 3-mm hex wrench, remove the battery bracket by removing
two screws.
4. Holding the battery so that the vent hole faces up and the Philips logo
faces out, thread the battery cable through the battery bracket.
Position and place the battery inside the battery compartment.
Pinching the end of the battery connector, plug it in so that it locks in
place.
5. Reinstall the battery bracket by replacing the two screws. Reinstall the
side panel and secure the fastener with a ¼ turn clockwise.
6. Make sure the battery is properly installed by plugging the ventilator
into an AC power receptacle and verifying that the yellow Battery
(charged) LED on the front panel flashes. The flashing LED indicates
the battery is being charged.