Circuit-, IC descriptions and list of abbreviations
EN 164
HDRW720/0x, DVDR725H/0x
9.
9.5.2
Record Mode
Block diagram Chrysalis Digital Board
Figure 9-5
Video Part
The analogue video input signals CVBS, YC, and YUV/RGB
(RGB for EURO and YUV for USA), are routed via the analogue
board to connector 1904 and sent to IC7004 (SAA7118, Video
Input Processor).
The digital video input signals are routed from the DV-In
connector (item 1200) via ICs 7200 (1394 PHY) and 7201
(1394 LINK) to IC7400 (PNX7100, Chrysalis).
The multistandard Video Input Processor (VIP, IC7400)
encodes the analogue video to digital video stream (CCIR656
format). It provides filtering of the analogue signals and
separation of luminance and chrominance by a comb filter. The
output stream, named ITU_IN(7:0), is then routed to the
Chrysalis IC (PNX7100). This IC encodes and decodes the
digital video stream into/from MPEG2 format.
Audio Part
I2S audio is sent from the analog board to the Chrysalis IC via
connector 1900. The Chrysalis compresses the I2S audio data
into an MPEG1-L2/AC3 audio stream.
Front-end I2S
IC7400 (Chrysalis) interfaces directly to the Basic Engine (BE)
via connectors 1100 (clock and data) and 1105 (control). For
future use (with AV3 BE module, HDD, or card reader) it also
interfaces to an IDE bus via connector 1102 .
It buffers the data streams that are coming from (or going to)
these hardware modules.
In the Chrysalis, the video MPEG2 stream and the audio AC3
stream are multiplexed into an I2S stream. The serial data are
sent to the Basic Engine for recording.
Front-end IDE Interface
IC7400 (Chrysalis) interfaces directly to the Basic Engine (BE)
IDE bus via connector 1102.
Via connector 1101 it connects to the hard disk.
The normal recording is always done on the hard disk. Only
archiving and playback is done with optical disk.
9.5.3
Playback Mode
During playback, the serial data from the Basic Engine is going
directly to the PNX7100 via the serial front-end I2S interface.
The PNX7100 is an MPEG CoDec and has the following
outputs:
•
To the analogue board: analogue video RGB, YC, CVBS
on connector 1904.
•
I2S audio (PCM format) on connector 1900.
•
SPDIF audio (digital audio output) on connector 1904.
•
Progressive video on connector 1704.
•
Communication gateway (RS232) on connector 1104.
(1) analogue CVBS / YC and RGB/YUV
(2) analogue CVBS, YC, RGB/YUV
(3) 2X16Mx16 can be mounted instead of
2x8Mx16 if necessary
SDRAM
2 X 8Mx16
(3)
IDE CONNECTOR
TO/FROM BE AV3
HDD, PCMCIA
BE AV2
UART I2S
I2C
EEPROM
64Kbit
VIP
SAA7118/19
1394
PID1394P25
I2C
EEPROM
64Kbit
OPTIONAL
CHRYSALIS
PNX7100
7400
7703
2FH DENC
OPTIONAL
2FH YUV
VIDEO
1FH VIDEO
OUT
(2)
DIG. AUDIO IN
OPT. & COAX
DIG. AUDIO OUT
I2S AUDIO OUT
I2S AUDIO IN
1FH VIDEO IN
(1)
I2C 0
I2C 0
I2C 1
7004
I2C0
CCIR656
CLOCK
7200
1200
OPTIONAL
OPTIONAL
7201
-5V
FROM POWER SUPPLY
5V
12V
3V3
XIO_1
XIO_0
XIO_0
XIO_0
1394
PID1394L40
1394
CONNECTOR
NORFLASH
4Mx8
NORFLASH
4Mx8
NANDFLASH
8Mx8
CL 36532004_003.eps
140203
7804/7812
Summary of Contents for DVDR725H
Page 148: ...EN 148 HDRW720 0x DVDR725H 0x 7 Circuit Diagrams and PWB Layouts ...
Page 171: ...Circuit IC descriptions and list of abbreviations EN 171 HDRW720 0x DVDR725H 0x 9 Figure 9 11 ...
Page 172: ...Circuit IC descriptions and list of abbreviations EN 172 HDRW720 0x DVDR725H 0x 9 Figure 9 12 ...
Page 193: ...Circuit IC descriptions and list of abbreviations EN 193 HDRW720 0x DVDR725H 0x 9 ...