PerkinElmer RamanStation 400, Getting Started Manual

Page: 82 / 118

82 . RamanStation 400 Series Getting Started Guide
Acquiring Spectra with the Fiber Optic Probe
The Raman Fiber Optic Probe (L1320002) has a tight focus spot that is approximately
7.5 mm away from the lens. The focused spot enables you to pinpoint the measurement area
on the sample.
Sampling Solids
Solids can be analyzed by mounting the probe on a stand and adjusting the focal spot on the
surface of the sample. Whenever possible, powders should be compacted down and thin
films of materials should be folded so that the sample covers the entire depth of field. Solids
can be analyzed in glass and plastic containers, similar to liquid samples.
NOTE: Raman spectra are measured in the visible and near infrared region. Room lights and
sunlight will contaminate your spectra. Take care not to misinterpret room lights or
sunlight features as Raman features.
Sampling Liquids
Liquid samples can be analyzed by immersing the FOP in the liquid of interest or by analyzing
through the container.
Immersion
The FOP can only be immersed in liquid if you have purchased an immersible fiber probe
sleeve. Do not totally submerge the probe. It is only acceptable to immerse the probe up to
1 inch from the top of the sleeve. It may be useful to focus the sample by sliding the FOP
inside the immersion sleeve to obtain the best spectrum. Note that immersion sleeves
contain either quartz or sapphire windows, these windows can yield a detailed Raman
spectrum – do not confuse this with the spectrum of the sample.
Figure 28 Fiber Optic Probe with the immersion sleeve detached
Immersion sleeve
Fiber optic probe