PERCo CT/L-04.2, Assembly And Operation Manual

Page: 37 / 70

Assembly & Operation Manual
Operation mode “ Closed” is mode of passage prohibition.

OD will be unblocked before the change of operating mode.

Pressing of buttons of remote control board and RC-button (“ Exit ”) are ignored.

When any card is presented, an event of access violation is registered.
Operation mode “ Security”
1
.

OD will be unblocked before the change of operating mode.

Pressing of buttons of RC-panel is ignored.

Protected zone is armed including the selected OD.

Passage through the OD (forced entry) sets the system into “ Alarm ” state.
11.2 Indication of ACS, events and controller configurations
Indication of operation modes, states and reactions of the controller to the presented
identifiers is performed on connected remote readers and indication blocks. Possible
variants of indications are shown in Table 7.
Note:

When reading an access control card in any operation mode, an audible signal
lasting 0.2 seconds is performed, yellow indicator changes his state for
0.2 seconds. The state of other indicators is not changed.

After the access is granted, indication is turned on for Unblocked state holding
period or until the passage is performed. When access is denied indication is
turned on for 1 second.
Table 7. Indication of the controller
Indicators
Card presentation
Operation
mode
Green Yellow Red
Sound
(sec.)
Configuration is not selected No 5 Hz 5 Hz 5 Hz off
Activating of input Fire Alarm Any card
1.3/0.2
2
off off off
“Open” on off off off
“Control” off on off off
“Security” off 1 Hz 1 Hz off
No
“Closed” off off on off
“Open” on off off 0.2
“Control”
Card is not authorized for access
“Security”
Any card
“Closed”
off off on 0.5
“Open”
“Control”
on off off 0.2
Card is authorized for access
“Security”
off off on 0.5
“Open”
“Control”
Card is authorized for access and for
arming/disarming
“Security”
1
on off off 0.2
1
Operation mode is available only for configuration “ Controller for the locks ” and for connected
CL-201 lock controllers.
2
Blinking (going off briefly) – 1.3 seconds is on, 0.2 seconds is off.
36