Assembly & Operation Manual
8.2 Installation order
Connection to the controller is performed in accordance with scheme shown on
Figures 3 - 13 with the use of cables from Table 6. The position of connecting blocks on
the controller’s board is presented on Figure 1.
Installation of connected devices (turnstiles, locks, power supply, etc.) is performed
according to the instructions given in technical documents of corresponding devices.
8.2.1 Controller installation
1. Unpack the box and check completeness of package contents according to Sect. 4.
Make sure that the equipment is not mechanically damaged.
2. Define the place for installation of the controller. Location of the controller should
comply with operational conditions. When choosing a location, make sure that it will be
convenient to perform service maintenance of the controller.
Attention!
Do not install the controller at a distance less than 1 m from a source of
electromagnetic interference.
3. Mark and drill holes in the surface to install the controller and connect cables in
accordance with Figure 2. Lay and mount communication cables, power cables and
Ethernet
cables to the location.
Figure 2. Marking of holes for the controller installation
20
Summary of Contents for CT/L-04.2
