PERCo CT/L-04.2, Assembly And Operation Manual

Page: 19 / 70

Assembly & Operation Manual
6 MARKING AND PACKAGING
The marking label of the controller is placed on the back of the housing. The marking label
provides following information concerning the controller:

trade mark and contact details of the manufacturer;

name and number of model;

serial number;

date and month of manufacture;

allowed power voltage range;

consumption current.
The controller board contains labels with default MAC-address and IP-address of the
controller.
The controller is packed into a paperboard box, preventing it from damages during
transportation and storage.
7 SAFETY REQUIREMENTS
7.1 Installation safety requirements
Installation and technical maintenance of the controller should be performed by qualified
staff, after getting acquainted with the Operation manual and safety rules. Installation
should be performed in accordance with general electrical and work safety rules.
Attention!

All connections and jumper installations should be carried out only when the
equipment is powered off and power supply is disconnected.

During mounting use only proper tools.

Cabling should be performed in accordance with general requirements for
electrical equipment.

Do not use the controller if it is not properly installed and connected.
7.2 Operation safety requirements
Operation should be performed in accordance with general electrical and work safety
rules.
Do not use!

The controller under conditions that do not comply with the requirements of
Section 2 of this Manual .

The controller at supply voltage that does not comply with the requirements of
Section 3 of this Manual.

The device in hostile environment that contains acids, alkalis, oils etc.
Power supply should be used accordingly to safety rules given in the Operation manual.
18