Installer manual Fleck 5800 XTR - Programming
Ref. MKT-IM-006 / E - 12.11.2019
51 / 126
Info
On metered units, the "Treatment" step on the regeneration cycle wheel will flash
when water is flowing through the unit.
7
Rapid Rinse
• Water flows from the top of the vessel to the bottom of the
vessel to rinse the media.
8
Tank Refill
• Brine tank is refilled with water.
9
Treatment
• The unit is treating water.
10
Day and time
• Displays the currently programmed day of the week and time.
This button will flash at the start-up and if the supercapacitor
is discharged
11
Next scheduled
regeneration
• Displays the time to next scheduled regeneration, or volume
remaining until regeneration in meter systems.
12
Backwash
• Water flows from the bottom of the vessel to the top of the
vessel to clean and mix the media.
13
Draw
• Brine is drawn into the media and then slowly rinsed out.
14
Pause
• Valve comes back in service position to allow brine
preparation after refill. Shown if variable refill/brining
regeneration flow has been selected in master setting.
15
Custom
• Shown if custom regeneration flow has been selected in
master setting.
16
Home
• Displays the home screen.
17
USB connect
• Allows you to connect the controller to a PC via a USB cable
for field programming or download of diagnostic parameters
via PC (Field Programmer application required).
18
Arrows
• Displayed in the upper-left and upper-right corners of the
screen, these arrows allow you to navigate from one screen
to another.
• Allow you to change the values of certain settings when
programming the controller.
Info
Settings on previous screen are not saved unless
is pressed.
19
Alarm
• Displayed when an error has occurred; accompanied with an
audible alarm. Press to silence the audible alarm.
20
Error
• Displayed when an error has occurred. Press to display the
error screen for more detailed error information.
