![background image](http://html1.mh-extra.com/html/parker/hmr-08-series/hmr-08-series_assembly-and-operating-instructions-manual_3903722041.webp)
41
EN
ATTENTION
It is not possible to lubricate the ball screw nut!
O-rings
for sealing off the lubrication channel are missing
or seated incorrectly.
► Check that the O-ring is seated correctly while pushing
underneath the carriage.
► Push the drive body with the
nut slot
under the
carriage
in such a way that the threaded holes are showing
upwards towards the carriage.
Before sliding in, twice insert the
O-rings
for sealing the lubricating joint in the counterbores of the nut slot.
For the following ensure that there is an exact axial alignment of the spindle:
► Screw 6 screws into the
nut slot
under the
carriage
. The screws are secured against coming loose with
Nord-Lock washers.
► Insert the free end of the spindle into the floating bearing in the
cover circulation
.
► Screw the cover drive onto the base profile. Only screw the screws in enough for the cover to remain
movable radially.
► Push the carriage until it is just in front of the cover drive side. With this the cover aligns radially to the
spindle nut.
► Align the cover drive side horizontally and gradually screw the cover screws down tightly.
► Push the carriage until it is just in front of the cover circulation side. With this the cover aligns radially to the
spindle nut.
► Align the cover circulation side horizontally and gradually screw the cover screws down tightly.
Nut slot
Carriage
O-rings
End cap non drive end