20
Modular Electric HMR Linear Drives
Mount the wipers and outer band
► Insert the
lateral
wipers
into the grooves on the carriage.
Pay attention to the alignment (lips should be facing outward).
► Place both
A-band coatings
on the holder cover. With this the sealing strips are visible and are on the
covers in each case.
► Place the
outer band
onto the center of the HMR.
ATTENTION
Premature wear of the Outer band
Twisted/distorted installation of the Outer band
► Careful tightening of the clamping strip
- Outer band not twisted
- Install without forming any ripples.
NOTE
► Adhere to the tightening torques for screws
according to section 7.1 on page 12.
► On one side, tightly clamp the
outer band
with the
clamping plate
and screw on.
Mount cover sheet and cover
► Lightly grease the bottom of the carriage
cover sheet
.
► On one side, insert the
cover sheet
into the groove of the carriage.
► Only
HMR08, 11
: push the
side cover
from the front into the grooves of the carriage.
► Only
HMR15, 18, 24
: Lock the
side cover
into position by applying central pressure from above onto the
opposite side. Note the correct position of the sealing strip in the carriage groove.
► Align the
carriage
cover
on the carriage and screw down tightly.
The outer band must have contact with the entire profile length without any ripples.
► Tightly clamp the
outer band
, without any tension, to the second
clamping plate
.
Lateral
wiper
Outer band
Clamping plate
outer band
Clamping plate
outer band
Cover sheet
Carriage cover
Outer band coating
Holder cover
HMRB
HMRB