38
Modular Electric HMR Linear Drives
Runner blocks
9.9.4 Installing the carriage belt drive
► Very carefully place the
carriage
onto the guide rails without tilting.
► When placing the
carriage
onto the guide rails, remove the transport safety device.
End cap non drive end
NOTE
► Adhere to the tightening torques for screws
according to section 7.1 on page 12.
► Place the
cover circulation
horizontally and in the centre and screw it in tightly.
► Carry back the belt on the upper side of the non drive end pulley.
► Fasten the cover to the end cap non drive end.
Subsequential steps can be done in opposite sequence then disassembly.
Finally tension the belt as per section 9.7.2 on page 34.
ATTENTION
Risk of damage to runner blocks!
Tilting will damage the recirculating ball runner block.
► Carefully move carriage onto the guide rails with a parallel
movement.
► Carefully move the
carriage
from the guide, without tilting and insert the transport safety device such that
no balls fall out of the
runner block
.
Carriage