Parker H Series, Installation & Service Instructions Manual

Page: 311 / 344

Publication PSS-UM001A-EN-P – December 2016
Use Auto Start Mode 3-3
Install the I/O Module
To install the module:
1. Using a bladed screwdriver, rotate the keyswitch on the mounting
base clockwise until the correct number for the I/O module aligns
with the notch in the base. (See the individual H Series Fieldbus
I/O module installation instructions for this number.)
2. Position the module vertically above the mounting base. The
module will bridge two bases.
3. Push the module down until it engages the latching mechanism.
You will hear a clicking sound when the module is properly
engaged.
The locking mechanism will lock the module to the base.
Remove the Module From the Mounting Base
To remove the module from the mounting base:
1. Put a fl at blade screwdriver into the slot of the orange latching
mechanism.
2. Push the screwdriver toward the I/O module to disengage the
latch. The module will lift up off the base.
3. Pull the module off of the base.
For more information on installing and wiring the multiple H Series
Fieldbus I/O modules, see the installation instructions for each catalog
number.
Module Will Bridge Two Bases
PSST8M12A
24V dc Out
MOD
NET
0
1
0
1
2
3
4
5
6
7
2
3
4
5
6
7