Parker H Series, Installation & Service Instructions Manual

Page: 269 / 344

Publication PSS-SG001A-EN-P – June 2005
Isysnet 1
Isysnet Product Compatibiliy
The following chart illustrates the compatibility of Isysnet with other control platforms, especially with Rockwell Automation. For
information regarding the differences between the networks and Isysnet, please refer to the Selecting a Network Interface section
in this document.
DeviceNet ControlNet EtherNet PROFIBUS
Adapter Adapter Adapter Adapter
PSSCDM PSSCCNA PSSCENA PSSCPBA
PLC-5™ with Network Port IOD NS NS NA
SLC 500™ with Network Port IOD NS NS NA
PLC-5 Processor via Network Module IOD NS NS 3
1756 Logix™ Communication Interface IOD IOD IOD 3
PanelView™ Terminal NA NA NA NA
RSLinx™ Software NA NA NA NA
1769-L20, -L30 Controller with
1761- NET Interface
NA NS NS NA
1769-L35E NA NA IOD NA
SoftLogix5800™ NS NS NS NA
PC with RSLinx Only NS NS NS NA
IOD = I/O Data
NS = Not Supported
NA = Not Applicable
3 = Requires third party scanner module
Communication Considerations
Isysnet features are impacted by your network choice.
Network Impact
DeviceNet PSSCDM12A and The PSSCDM12A and PSSCDM18PA provide two means of
PSSCDM18PA connecting a node of I/O to DeviceNet.
A total of 63 Isysnet modules can be assembled on a single DeviceNet node.
Expansion power supplies may be used to provide additional PointBus backplane current.
ControlNet™ PSSCCNA A total of 63 Isysnet modules can be assembled on a single ControlNet node.
Expansion power supplies may be used to provide additional PointBus backplane current.
Up to 25 direct connections and 5 rack connections are allowed.
EtherNet/IP™ PSSCENA A total of 63 Isysnet modules can be assembled on a single EtherNet/IP node.
Expansion power supplies may be used to provide additional PointBus backplane current.
Refer to the User Manual, publication PSS-UM004 to determine the ratings for direct and
rack connections allowed.
PROFIBUS DP™ PSSCPBA A total of 63 Isysnet modules can be assembled on a single PROFIBUS node.
Expansion power supplies may be used to provide additional PointBus backplane current.