Parker 590 series, Product Manual

Page: 89 / 242

The Man-Machine Interface (MMI)
5-7
590 Series DC Digital Converter
How to Save, Restore and Copy your Settings
Saving Your Application
Note: Ensure that CONFIGURE ENABLE = DISABLED before performing
a PARAMETER SAVE (when set to ENABLED, the drive cannot run).
The PARAMETER SAVE menu, available in the both the full and
reduced view levels, is used to save any changes you make to the MMI
settings.
Pressing the
↑
(UP) key, as instructed, saves all parameter
values in non-volatile memory, i.e. values are stored
during power-down.
Restoring Saved Settings
If you are unsure about any changes you have made and you have not yet performed a
PARAMETER SAVE, simply switch the Converter off, and power-up again. The “last saved”
parameter settings will be restored.
Copying an Application
Copying an application requires a host computer connection to the Converter’s P3 port.
Information can then be downloaded to the computer (and uploaded to the Converter).
Refer to Chapter 14: “Serial Communications” for further information.
MMI Menu Map
1 SYSTEM
2 CONFIGURE I/O
CONFIGURE ENABLE
1
1
UP TO ACTION
PARAMETER SAVE