Parker 10G-11-0015 Series, Product Manual

Page: 91 / 147

Function Parameters
9-43
AC10 Inverter
2: 4800;
3: 9600;
4: 19200
5: 38400
6: 57600
F904=9600 is recommended for baud rate.
F905 Communication timeout period Setting range: 0
～
3000 Mfr’s value: 0
When F905 is set to 0.0, the function is invalid. When F905
≠
0.0, if the inverter has not
received effective command from PC/PLC during the time set by F905, inverter will trip into CE.
Communication parameters refer Chapter 13 The Default Applications.
9.10 PID Parameters
Internal PID adjusting control is used for simple close-loop system with convenient operation.
FA01 PID adjusting target given source Setting range:
0: FA04
1: AI1
2: AI2 Mfr’s value: 0
When FA01=0, PID reference target is given by FA04 or MODBUS.
When FA01=1, PID reference target is given by external analog AI1.
When FA01=2, PID reference target is given by external analog AI2.
FA02 PID feedback signal given source Setting range:
1: AI1
2: AI2 Mfr’s value: 1
When FA02=1, PID reference feedback signal is given by external analog AI1.
When FA02=2, PID reference feedback signal is given by external analog AI2.
FA03 Max limit of PID adjusting (%) FA04
～
100.0 Mfr’s value
：
100.0
FA04 Digital setting value of PID adjusting (%) FA05
～
FA03 Mfr’s value
：
50.0
FA05 Min limit of PID adjusting (%) 0.1
～
FA04 Mfr’s value
：
0.0
When FA01=0, the value set by FA04 is digital setting reference value of PID adjusting.
FA06 PID polarity
0: Positive feedback
1: Negative feedback
Mfr’s value
：
1
When FA06=0, the higher feedback value is, the higher the motor speed is. This is positive
feedback.
When FA06=1, the lower the feedback value is, the higher the motor speed is. This is negative
feedback.
FA07 Sleep function selection Setting range:
0: Valid
1: Invalid Mfr’s value: 1
When FA07=0, if inverter runs at the min frequency FA09 for a period time set by FA10, inverter
will stop.
www.comoso.com