Parker 10G-11-0015 Series, Product Manual

Page: 21 / 147

The Menu Organisation
6-2
AC10 Inverter
6.2 Function Codes Switchover in/between Code-Groups
It has more than 300 parameters (function codes) available to user, divided into sections as
indicated in Table 6-3.
Table 6-3 Function Code Partition
Group Name
Function
Code Range
Group
No.
Group Name
Function
Code Range
Group
No.
Basic Parameters F100
～
F160 1
Timing control and
protection
function
F700
～
F770 7
Run Control Mode
F200
～
F280
2
Parameters of the
motor
F800
～
F850
8
Multi-functional
input/output terminal
F300
～
F340
3
Communication
function
F900
～
F930
9
Analog signals and
pulse of input/output F400
～
F480
4
PID parameter
setting
FA00
～
FA80
10
Multi-stage speed
Parameters
F500
～
F580
5 Torque control FC00~FC40 11
Subsidiary function F600
～
F670 6
As parameter setting can take time due to numerous function codes, such function is specially
designed as “Function Code Switchover in a Code Group or between Two Code-Groups” so
that parameters setting becomes convenient and simple.
Press “M” key so that the keypad controller will display function code. If user presses “▲” or “▼”
key, the function code will circularly keep increasing or decreasing by degrees within the group;
if user presses the “O” key again, the function code will change circularly between two code
groups when operating the “▲” or “▼” key, e.g. when function code shows F111 and DGT
indicator is on, press “▲”/ “▼” key, function code will keep increasing or decreasing by degrees
within F100
～
F160; press “O” key again, DGT indicator will be off. When pressing “▲”/ “▼” key,
function codes will change circularly among the 10 code-groups, like F211, F311…FA11,
F111…, Refer to Figure 6-1 (The flashing “ is indicated the corresponding target
frequency values).
Figure 6-1 Switch over in a Code Group or between Different Code-Groups
Enter correct user’s password
(currently showing
50.00
)
M
Display
Display
DGT
O
Display
DGT
▲
Display
▲
Display
▲
Display
DGT Off
DGT On
www.comoso.com