2.7.4.7 Configure settings relating to HTTP alarm notification when an
alarm occurs
Click “HTTP alarm notification setup >>” of “Camera action on alarm” on the [Alarm] tab of the “Alarm” page.
(
Refer to page 172 for information on configuration for these settings.
2.7.5 Configure the VMD settings [VMD area]
Click the [VMD area] tab on the “Alarm” page. (
®
For menu display and how to operate, refer to page 47,
page 48)
The video motion detection areas can be set on this page.
The VMD areas can be set up to 4 areas for each preset position (maximum 256 preset positions). When
motion is detected in the set area, it will be regarded as an alarm.
The camera can be configured to take an alarm action even when the camera is not at the preset position.
IMPORTANT
•
The alarm occurrence indication button (
®
page 12) will be displayed when motion is detected by the
VMD function.
•
The alarm occurrence indication button will be displayed when receiving an alarm input of a terminal
alarm or a command alarm.
•
Depending on the network environment, notification may be delayed even when “Real time” is selected
for “Status update mode” on the [Basic] tab of the “Basic” page (
•
After configuring the VMD area, the VMD area may move out of alignment when “Image capture
mode” of the [Image] tab is changed. Make sure to check the VMD area after changing the “Image
capture mode” setting.
•
The motion detection function is not the dedicated function to prevent thefts, fires, etc. We are not
responsible for any accidents or damages that may occur.
162
Operating Instructions
2 Settings