Panasonic Switch-M12PWR, Operation Manual

Page: 94 / 240

94
Available commands are listed below.
N Display the next page.
Press "N" to display the next page.
P Display the previous page.
Press "P" to display the previous page.
T Set System Priority value of this Switching Hub in LACP.
Press "T." The command prompt changes to "Enter system priority for LACP >."
A Configure new trunking settings.
Press "A." The command prompt changes to "Enter trunk group admin key>."
Enter a group number you wish to configure. The command prompt changes to
"Enter port member for group key #>." Enter a port number you wish to do
trunking. When entering multiple port numbers, delimit with comma (,) with no
space (example: "1,2,3"), or hyphenate the continuous numbers (example: "8-12").
Then, the command prompt changes to "LACP Active, LACP Passive or Manual
trunk setting(A/P/M)>." Enter "A" to make operation mode Active, or "P" to make
it Passive, or "M" to make it Manual, respectively.
R Remove trunking settings.
Press "R." The command prompt changes to "Enter trunk group admin key>." Enter
a group number you wish to delete. The command prompt changes to "Enter port
member port for group key #>." Enter a port number you wish to do rdelete.
When entering multiple port numbers, delimit with comma with no space, or
hyphenate the continuous numbers.
M Modify the operation mode of trunking.
Press "M." The command prompt changes to "Enter trunk group admin key>."
Enter a group number you wish to modify. Then, the command prompt changes
to "LACP Active, LACP Passive or Manual trunk setting(A/P/M)>." Enter "A" to
make operation mode Active, or "P" to make it Passive, or "M" to make it Manual,
respectively.
O Set System Priority value of this Switching Hub by port in trunking.
Press "o" to open the "Set port Priority" screen. For method of detail setting, refer
to the section (4.7.2.c).
G Display a status of LACP group.
Press "G." The command prompt changes to "Enter trunk group number >." Enter a
key of group you wish to display. (Only the group of which mode is Active or
Passive can be entered.) Then, screen changes to "LACP Status." For details, refer
to the section (4.7.2.d).
Q Return to the previous menu.
Note: In this Switching Hub, it is possible to set members of up to 12 ports
to one group, but it is up to 8 ports that execute trunking operation.
Members after the 9th port in that group get into backup mode.
When a failure occurred in link of 1–8 port, one of them becomes a
member that constructs trunk on behalf of that port. In this case,
priority order to become a member is determined by Port Priority
that is set in next section (4.7.2.c), and, when Priority value is the
same to all, trunk is constructed by a member starting from the
smallest port number in order.