Panasonic Switch-M12PWR, Operation Manual

Page: 37 / 240

37
Available commands are listed below.
I Set/edit the IP address.
Press "I." The command prompt changes to "Enter IP address>." Enter an IP
address for the Switching Hub.
M Set/edit the subnet mask.
Press "M." The command prompt changes to "Enter subnet mask>." Enter a subnet
mask for the Switching Hub.
G Set/edit the IP address of the router for the default gateway.
Press "G." The command prompt changes to "Enter new gateway IP address>."
Enter the IP address of the router, set as the default gateway.
A Set the IP address, subnet mask and default gateway in succession.
Press "A." The command prompt changes to "Enter IP address>." Enter the IP
address of the Switching Hub. Then, the command prompt changes to "Enter
subnet mask>." Enter the subnet mask. Then, the command prompt changes to
"Enter new gateway IP address>." Enter the IP address of a router, used as a
default gateway.
D Disable/enable the DHCP mode. If enabled, an IP address is automatically obtained
from the DHCP server.
E Enable the DHCP mode. (A DHCP server must be operating on the network.)
D Disable the DHCP mode.
R Renew an IP address from the DHCP server.
Press "R." The command prompt changes to "Renew DHCP (Y/N)." To renew, press
"Y." Otherwise, press "N."
Q Return to the previous menu.
Note: The above items must be set in order to use the SNMP control
function and to enable a remote connection by Telnet or via WEB.
Any IP addresses on the local network must be unique and no
duplication is allowed. If you are unsure, consult the network
administrator.