Panasonic Switch-M12PWR, Operation Manual

Page: 121 / 240

121
4.7.4.g MST Instance Topology Information
On the MSTP Instance Configuration, pressing "I" and entering MST instance
ID open the MST Instance Topology Information screen, as shown in Fig.
4-7-22. On this screen, you can do setting MST Instance Topology
Information.
Fig. 4-7-22 MST Instance Topology Information
Screen Description
MST Instance: Displays selected MST instance ID.
Port Displays the port number.
Trunk Displays the group number (key) of the trunk if trunking is set.
Link Displays the state of link.
UP
Link is established normally.
DOWN Link is not established.
Desig.Root Displays root bridge ID.
Desig.Cost Displays cost under transmission.
Desig.Bridge Displays bridge ID of a designated bridge.
Desig.Port Displays port ID of a designated port. (Port ID is a combination of port
priority value and port number.)
Available commands are listed below.
N Display the next page.
Press "N" to change the display to the next page.
P Display the previous page.
Press "P" to change the display to the previous page.
PN23129K/PN23129A Local Management System
MSTP Instance Configuration -> MST Instance Port Configuration
MST Instance: xx
Port Trunk Link State Role Priority Path Cost STP Status
---- ----- ---- ---------- ---------- --------- --------- ----------
1 --- Down Discarding Disabled 128 200000(A) Enabled
2 --- Down N/A N/A 0 0 N/A
3 --- Down N/A N/A 0 0 N/A
4 --- Down N/A N/A 0 0 N/A
5 --- Down N/A N/A 0 0 N/A
6 --- Down N/A N/A 0 0 N/A
7 --- Down N/A N/A 0 0 N/A
8 --- Down N/A N/A 0 0 N/A
9 --- Down N/A N/A 0 0 N/A
10 --- Down N/A N/A 0 0 N/A
11 --- Down N/A N/A 0 0 N/A
12 --- Down N/A N/A 0 0 N/A
-------------------------------- <COMMAND> -----------------------------------
Set Port Pr[i]ority [N]ext Page
Set Port Path [C]ost [P]revious Page
Set Port STP [S]tatus [Q]uit to previous menu
Command>
Enter the character in square brackets to select option