Panasonic Switch-M12PWR, Operation Manual

Page: 152 / 240

152
4.7.6.a. Traffic Class Configuration
On the Quality of Service Configuration Menu, pressing "T" opens the Traffic
Class Configuration screen, as shown in Fig. 4-7-39. On this screen, you can
set QoS in packets.
Fig. 4-7-39 Traffic Class Configuration
Screen Description
QoS Status: Displays the status of QoS function using IEEE802.1p.
Enabled
QoS is enabled.
Disabled QoS is disabled. (Factory default setting)
Priority Displays a priority value in a packet tag.
Traffic Class Displays the packet priority.
Available commands are listed below.
S Switch enabled/disabled of the QoS function.
Press"S" to change the command prompt to "Enable or Disable QoS (E/D)>." To
enable the QoS function, press "E." To disable it, press "D."
M Assign priority (Traffic Class) to a priority value of IEEE802.1p.
Press "M" to change the command prompt to "Enter Priority (E/D)>." Enter a
priority value (0 to 3) to be assigned. Then, the command prompt changes to
"Enter traffic class for priority #>." Enter Traffic Class (0 to 7).
C Move to the screen for configuring a scheduling method.
Press "C" to change the screen to Scheduling Method. Refer to the section 4.7.6.b
for how to set.
Q Return to the previous menu.
PN23129K/PN23129A Local Management System
Quality of Service Configuration -> Traffic Class Configuration Menu
QoS Status: Disabled
Priority Traffic Class
-------- -------------
0 1
1 0
2 2
3 3
4 4
5 5
6 6 0: Lowest
7 7 7: Highest
-------------------------------- <COMMAND> -----------------------------------
[S]et QoS Status [Q]uit to previous menu
Set Priority-Traffic Class [M]apping
Scheduling Method [C]onfig.
Command>
Enter the character in square brackets to select option