Panasonic KX-TA1232, Programming Manual

Page: 115 / 216

General Programming
Programming Guide 115
[403] Pulse Speed Selection
Description
An outside line set for pulse or call blocking mode in program [402] Dial Mode Selection
can have two pulse rates, 10 pps (low) and 20 pps (high). This program sets the pulse speed for
each outside line set to pulse or call blocking mode.
Selection
• Outside line (CO) number: 01 through 12, ( =all outside lines)
• 10 pps / 20 pps
Default
All outside lines — 10 pps
Programming
1.
Enter 403.
Display: 403 PULSE SPEED
2.
Press NEXT.
Display: CO Line NO?
3.
Enter an outside line number.
To enter outside line number 01, you can also press NEXT.
Display example: CO01:10pps
4.
Keep pressing SELECT until the desired selection is displayed.
5.
Press STORE.
6.
To program another outside line, press NEXT or PREV, or SELECT and the desired
outside line number.
7.
Repeat steps 4 through 6.
8.
Press END.
Conditions
• To assign all outside lines to one selection, press the key in step 3. In this case, the display
shows the contents programmed for outside line 01.
• The pulse speed required is determined by the outside or PBX line.
• Program [990] System Additional Information, Area 02 - Bit 7 and 12, 11 are used to
select a pulse break ratio and inter-digit pause, if needed.
Features Guide References
Dial Type Selection
pg.book 115 ページ ２００１年７月３日 火曜日 午後２時４４分