Panasonic DP-8032, Service Manual

Page: 90 / 397

90
DP-8032/8025
2008 Ver.1.2
Note:
1. Clean all Rollers and Separation Rubber with a soft cloth saturated with water.
For stubborn toner accumulation, wipe with a soft cloth saturated with Isopropyl Alcohol first, then
follow up with a soft cloth saturated with water.
2. The Maintenance Cycle is based on the Counter Information for each individual module.
To verify the counter information, print the Total Counter List using the Service Mode: F7 - Electronic
counter - 00 (List print).
3. Cleaning, Replacement and Adjustment Cycle (Sheet) are based on using Panasonic's recommended
standard paper and supplies. These cycles may vary with the kind of paper used and/or ambient
conditions.
4. The value is determined under the following test conditions. Four continuous prints per job using 6%
image coverage of LT/A4 size.
33 Thermostat 1038 60K Dry soft cloth -
Refer to
2.2.5.
F7-02-00
34 Bearing 1039 - - 240K
35 Thermistor Assembly 1041 60K Dry soft cloth 480K
36 Fuser Lamp (450W) 1043 - - 240K
37 Fuser Lamp (600W) 1044 - - 240K
38 Fuser Roller Bearing 1046 - - 240K
39
(Available for Japan
Only)
- - - -
40 Upper Finger 1067 60K Alcohol 480K
41 Web Pressure Roller 1080 - - 480K
42 Cleaning Web Roller 1083 - - 120K F7-02-08
Dual-Path Exit Guide
43 Feed Roller 1510 60K
Water
1
-
Refer to
2.2.5.
F7-02-01
44 Idle Roller 1511 60K
Water
1
-
Automatic Duplex Unit
45 Drive Roller 1409 60K
Water
1
-
Refer to
2.2.7.
F7-03-06
46 Drive Roller 2 1410 60K
Water
1
-
Paper Transportation
47 Drive Roller 1314 60K
Water
1
-
Refer to
2.2.11.
F7-02-01
No. Mechanical Parts
Ref.
No.
Cleaning Replacement/Adjustment
Ref.
Counter
Cycle
(Sheet)
Method
Cycle
(Sheet)
Procedure