Panasonic DP-8032, Service Manual

Page: 342 / 397

342
DP-8032/8025
2008 Ver.1.2
9.1.3. Using a PC to Input the Internet Parameters Remotely
This feature provides a convenient, and an easy way to input the Internet Parameters right from your PC by
sending a text email message to your machine.
The following parameters can be input remotely via a PC. The other parameters must be entered from the
machine in the User Parameters. (See Operating Instructions for Facsimile and Internet Fax/Email
Functions.)
- Sender Selection (up to 24 User Names, see Operating Instructions for Facsimile and Internet Fax/
Email Functions.)
- Default Domain
- Selectable Domains (up to 10 additional Domain Names)
- Remote Password
- Manager’s Email Address
- Relay XMT Password
- Relay Domain (up to 10 Domain Names authorized for Relay XMT Request)
- LDAP Server Name (Available for some countries only.)
- LDAP Login Name (Available for some countries only.)
- LDAP Password (Available for some countries only.)
- LDAP Search Base (Available for some countries only.)
- Community Name (up to 2 Community Names)
- Device Name
- Device Location
Your machine interprets the command that you enter in the “Subject” line of your email message, and
performs one of the following functions, it Retrieves, or Stores data into the Internet Parameters (User
Parameters).
The two types of commands that can be entered in the “Subject” line of your email:
1) To Store data, type : #set parameters(password)# : where the “password” is the Remote
Password programmed in your machine’s
User Parameters (i.e. 1234567890).
You can enter the Internet Parameters
shown above with this command the first
time. However, if these fields already
contain data, do not use this command as
the existing information will be deleted, and
overwritten. Use the Retrieve command
below instead, refer to the next pages.
2) To Retrieve data, type : #get parameters(password)#
Note:
To activate this feature, change the Fax Parameter No. 158 (PC Remote Update) to “Valid”.
(See Operating Instructions for Facsimile and Internet Fax/Email Functions.)
9.1.4. To Retrieve Each Parameters
To retrieve the existing parameters, send a plain text email to the your machine’s email address with the
following command in the “Subject” line:
- #get parameters(password)# : To retrieve the Internet Parameters
- #get abbr(password)#
: To retrieve the Auto Dialler (Address Book Dialler)
- #get jnl(password)# : To retrieve the Journal (Transaction Journal)
: where the “password” is the Remote Password programmed in your machine’s User Parameters
(i.e. 1234567890). For security, always input a Remote Password in the User Parameters. If it was
not programmed, signify with “()” (i.e. #get parameters()#).
Make sure that the Cc..., Bcc... lines, and the body of the email message is Blank.