Panasonic AJ-CX4000G, Operating Instructions Manual

Page: 97 / 221

– 97 –
Chapter 4 Operation — Menu settings
[FRAME RATE] Selects the image information (such as frame rate) of the camera.
[USER] Selects the set user bits.
[TIME] Selects the local time. (hh, mm, ss)
[DATE] Selects the local date and time. (YY, MM, DD, hh)
[TC] Records the time code value as user bits.
[CLIP NAME] Records the value that CAM INDEX (one character) and CARD COUNT (three-digit number) are converted to ASCII
character code. Only enabled when the [SYSTEM] menu → [FILE FORMAT] → [MOV] is set.
(Factory setting: [USER])
[TC IN/OUT SEL]
Sets the input/output of the <TC IN/OUT> terminal.
[TC IN] Sets to the time code input.
[TC OUT] Sets to the time code output.
(Factory setting: [TC IN])
[TC OUT REF]
Sets the output delay of the time code that is output from the <TC IN/OUT> terminal.
[RECORDING] Outputs the recording time code without delay. This is used when performing simultaneous recording on two cameras with
the time code of this camera as the master.
[SDI OUT1] Matches to the output image from the <SDI OUT1> terminal. Outputs without delay when the image is not output from the
<SDI OUT1> terminal.
(Factory setting: [RECORDING])
[REC COUNTER]
Sets operation of the counter for recording.
[TOTAL] Performs continuous counting until it is reset by pressing the <RESET> button.
[CLIP] Clears the counter value at the start of recording and counts the time for each recording.
(Factory setting: [TOTAL])
[NETWORK] menu
Specifies the network function settings.
[DEVICE SEL]
Select the device that connects external equipment (computer, etc.) to the camera.
The camera may restart when the setting is changed.
[LAN] Connects via a wired LAN.
[WLAN] Connects via a wireless LAN.
[OFF] Does not connect.
(Factory setting: [OFF])
[NETWORK FUNC]
Selects the network function of the camera.
[STREAMING] Enables the streaming function.
[NDI | HX] Enables the NDI | HX function.
[OFF] Disables the network function.
(Factory setting: [OFF])
@ @
NOTE
t When [NDI | HX] is selected, recording and thumbnail display are not possible.
[IP REMOTE]
Perform settings for the IP remote. (remote control by the CX ROP app)
[ENABLE/DISABLE]
Sets whether to enable the IP remote function.
The items that can be set are as follows.
f [ENABLE], [DISABLE]
(Factory setting: [DISABLE])
[USER ACCOUNT]
Registers a new user account to use for authentication in the network function of the camera. (Maximum of ten accounts)