Panasonic AJ-CX4000G, Operating Instructions Manual

Page: 206 / 221

– 206 –
Chapter 10 Maintenance — Warning system
Message
Screen display
Description Behavior and cause
Camera image screen
[CANNOT PLAY.] This is a clip that cannot be played back.
(When it cannot be played back due to difference of the
system frequency, etc.)
An error has occurred during playback, and the playback
has stopped.
A message is displayed.
f Confirm if the system frequency of the clip is the same as
the system frequency of the camera.
f Check the clip.
[CANNOT DELETE.] This is a clip that cannot be deleted. A message is displayed.
f Match the device and content versions.
[CANNOT RECORD. THE NUMBER
OF CLIPS HAS EXCEEDED THE
MAXIMUM LIMIT.]
The number of clips that can be recorded has reached the
maximum.
A message is displayed.
f Replace the memory card or delete unnecessary clips.
[CARD ERROR. PLEASE
REFORMAT.]
Formatting of the memory card has failed. A message is displayed.
f Format it again.
[COPY IMPOSSIBLE. TOO LARGE
CLIP CONTAINED.]
The P2 clip exceeding 4 GB cannot be copied to a
memory card of 32 GB or less.
A message is displayed.
f Copy to a memory card with the capacity exceeding
32 GB.
[CANNOT COPY TO SAME CARD.] The clip recorded over multiple memory cards cannot be
copied to a same memory card.
A message is displayed.
f
Copy to a memory card not containing a clip that is
recorded over multiple memory cards.
[Repair failed.] Repairing the clip where an error occurred has failed
because the power was disconnected or the memory card
was removed during recording.
Restoring of the management information has failed.
A message is displayed.
f Check the memory card.
[REINSERT OR CHECK CARD.] This memory card cannot be formatted. A message is displayed.
f Check the memory card.
[CANNOT PROTECT.] This is a clip that cannot be protected. A message is displayed.
f Match the device and content versions.
[THE CLIP IS PROTECTED. PLEASE
CANCEL PROTECTION.]
The clip is protected so it cannot be deleted. A message is displayed.
f Cancel the protect on the clip.
[CANNOT DELETE UNTIL TOP
MENU IS DELETED. DELETE TOP
MENU? (RECORDED DATA WILL
NOT BE DELETED)]
The camera is trying to delete a clip on the memory card
where the top menu has been created.
A message is displayed.
f Delete the top menu.
[CANNOT RECORD UNTIL TOP
MENU IS DELETED. DELETE TOP
MENU? (RECORDED DATA WILL
NOT BE DELETED)]
The memory card where the top menu was created has
been inserted.
A message is displayed.
f Delete the top menu.
[THUMBNAIL DATA ERROR IS
DETECTED.]
An error occurred in the thumbnail information of the
memory card.
A message is displayed.
f Restoring of the management information is performed
automatically after this.
[CANNOT RECORD -
INCOMPATIBLE CONTROL DATA.]
The version of the management information on the
memory card is not supported.
A message is displayed.
f Match the device and content versions.
[CANNOT SET.] This cannot be set. A message is displayed.
f Perform the setting after making it possible to set.
[THIS CLIP CANNOT BE COPIED.] The clip cannot be copied. A message is displayed.
f Copy the clips other than the corresponding clip.
[CONTROL DATA ERROR HAS BEEN
DETECTED. (SD CARD)]
An error occurred in the management information of the
memory card.
A message is displayed.
f Restoring of the management information is performed
automatically after this.
[COPY FAILED. PLEASE CHECK
THE CARD.]
The clip has failed to copy due to an error in the memory
card.
A message is displayed.
f Check the memory card.
[COPY TERMINATION IN
PROGRESS DUE TO INSUFFICIENT
BATTERY POWER. DO NOT SWITCH
OFF.]
Remaining battery level became low while copying the
clip.
A message is displayed.
f The copy is canceled.
f Replace with a fully charged battery, or connect the
external DC power supply.
[COPY TERMINATED DUE TO
INSUFFICIENT BATTERY POWER.]
Copying of a clip is canceled due to insufficient remaining
battery level.
A message is displayed.
f Replace with a fully charged battery, or connect the
external DC power supply.
[CANNOT COPY - THE NUMBER OF
CLIPS HAS REACHED MAXIMUM.]
The number of clips that can be copied has reached the
maximum.
A message is displayed.
f Replace the memory card in the copy destination or
delete unnecessary clips.
[LOW BATTERY. PLEASE CONNECT
AC ADAPTOR OR CHANGE
BATTERY.]
It is trying to copy a clip or update the camera firmware
while the remaining battery level is insufficient.
A message is displayed.
f Replace with a fully charged battery, or connect the
external DC power supply.
[CANNOT PLAY THIS CLIP ON THIS
MODEL.]
This is a clip that cannot be played back with the camera. A message is displayed.
f Playback on a device that can playback.
[ERROR HAS OCCURRED. TO
REPAIR THE CONTROL DATA,
PLEASE CONNECT AC ADAPTOR
OR CHANGE BATTERY.]
The remaining battery level was low when the restoring of
the management information is started.
A message is displayed.
f Replace with a fully charged battery, or connect the
external DC power supply.