Panasonic AJ-CX4000G, Operating Instructions Manual

Page: 20 / 221

– 20 –
Chapter 2 Description of Parts — Power supply and accessory mounting section
Power supply and accessory mounting section
4 5 6 7 8 1
14
13
15
20
16 17 11
18
19
3
9
11
2
10
12
10
1 Power switch
Switches between power on/standby.
To turn on, set the power switch to <
j > (ON). To set to standby, set the power switch to < h > (standby).
@ @
NOTE
t Even when the power switch is set to the < h > (standby) position, the camera is not shut off from the main power.
2 Viewfinder left/right positioning ring
To adjust the left/right position of the viewfinder, loosen this ring, and slide the viewfinder to the left or right to adjust it to an easy-to-view position.
After adjustment, turn in the <LOCK> direction and firmly clamp.
3 <VF> terminal
Mount the viewfinder AG-CVF15G (optional), AJ-CVF50G (optional), etc.
4 Mount cap
Raise the lens lever to remove the cap. Replace the cap when the lens is not mounted.
5 Cable holders
Fix the cables for lens or microphone.
6 Lens mount
Mounts the 2/3-inch bayonet lens.
7 Tripod mount
Attaches the tripod adaptor SHAN-TM700 (optional). (bottom)
8 Lens lever
After mounting the lens to the lens mount, tighten the lens lever to secure the lens.
9 <LIGHT> switch
Select how to turn on/off the video light connected to the <LIGHT> terminal.
<AUTO>: When the video light is left turned on, the light is illuminated at the same time that recording starts on the camera and goes out at the
same time that recording stops.
<MANUAL>: The light is illuminated according to whether the video light is turned on/off.
10 Viewfinder front/back positioning lever
To adjust the front/back position of the viewfinder, loosen this lever, and slide the viewfinder to the front or back to adjust it to an easy-to-view
position. After adjustment, turn in the <LOCK> direction and firmly clamp.
11 Shoulder strap mounting section
Mounts the supplied shoulder strap. (page 44)
12 Battery release lever
Used when removing the battery from the camera.
13 Battery holder
Mounts the Anton/Bauer battery (optional).
14 <DC IN> terminal
This is the input terminal for the external power supply. Connect to the external DC power supply.
15 <DC OUT> terminal
This is the DC12 V power supply output terminal. It provides a maximum current of 1.5 A.
@ @
NOTE
t Make sure that polarity is correct before connecting an external device. Doing so may result in a malfunction.