Panasonic AJ-CX4000G, Operating Instructions Manual

Page: 86 / 221

– 86 –
Chapter 4 Operation — Menu settings
(Factory setting: [MENU ONLY])
[HDMI OUT]
[SIGNAL SEL]
Sets the signal to output from the <HDMI> terminal.
The items that can be set are as follows.
f [SDI OUT1(2160p)], [SDI OUT2]
(Factory setting: [SDI OUT2])
@ @
NOTE
t [SDI OUT1(2160p)] can be selected only when [OUT FORMAT] of [SDI OUT1] is set to [3840 × 2160p].
This is fixed to [SDI OUT2] when [OUT FORMAT] of [SDI OUT1] is set to anything other than [3840 × 2160p].
[HDMI TC OUT]
Sets if the time code information is output or not in the output from the <HDMI> terminal.
The items that can be set are as follows.
f [ON], [OFF]
(Factory setting: [OFF])
[HDMI REC REMOTE]
Sets if the recording operation against the external equipment connected to the <HDMI> terminal (such as recorder) is to be controlled or not. This can
be set when [HDMI TC OUT] in [HDMI OUT] is enabled.
[ON] Controls the recording operation of the external equipment.
[OFF] Does not control the recording operation of the external equipment.
(Factory setting: [OFF])
@ @
NOTE
t This cannot be set when set to the [RECORDING] menu → [REC FUNCTION] → [REC MODE] → [INTERVAL].
[SD DOWNCON MODE]
Sets the mode of the SD down converter output signal from the <SDI OUT2>/<HDMI OUT> terminal.
[SIDE CROP] Outputs an equal top and bottom width.
[LETTER BOX] Outputs an equal right and left width.
[SQUEEZE] Outputs by compressing in the horizontal direction to fit the screen.
(Factory setting: [LETTER BOX])
[VF COLOR]
Selects whether to display viewfinder images in color or in black and white.
[ON] Displays in color.
[OFF] Displays in black and white. The playback image, thumbnail screen, and menu display will be kept in color.
(Factory setting: [ON])
[LCD]
[BRIGHTNESS]
Adjusts the brightness of the LCD monitor.
The items that can be set are as follows.
f [ − 15]…[15]
(Factory setting: [0])
[COLOR LEVEL]
Adjusts the color level of the LCD monitor.
The items that can be set are as follows.
f [ − 15]…[15]
(Factory setting: [0])
[CONTRAST]
Adjusts the contrast of the LCD monitor.
The items that can be set are as follows.
f [ − 30]…[30]
(Factory setting: [0])
[BACK LIGHT]
Adjusts the brightness of the LCD monitor backlight. [0] is the standard brightness.