1
2
Functional De
scrip
tion
PC system via Gig-E or USB
(basic version)
The camera can also be controlled with the WEISSCAMware via a PC System instead of the
Hand Unit HU-2. The prerequisite for camera operation via PC System is an
NVIDIA
graphics
card (Minimum: 8000 series). The camera must be connected to the PC System via a Gigabit
Ethernet or USB cable. Please note that Gigabit Ethernet delivers a higher data rate. For this pur-
pose, plug the cable into the INT input on the rear side of the camera and connect it to a free PC
System port.
WEISSCAM DigiMag DM-2
For single link data transfer, connect a BNC cable (75 ohms) to “HD-SDI LINK A” (for HD-Stream)
or “RAW LINK A” (for RAW-Stream) on the camera side and the BNC signal input on the recorder
side.
For dual link (and dual stream) data transfer, connect one BNC cable (75 ohms) each to HD-SDI
LINK A & B on the camera side. Connect the respective BNC cables on the recorder side to the
compatible HD-SDI inputs.
For dual link data transfer, be absolutely certain that the cables have the same length
and identical cable grade.
Viewfinder
The electronic viewfinder (included in stand alone version) should be powered via the 12V connec-
tion of the camera.
Connection on the rear side of the camera: "12V (0.5A) DC OUT" (4-pin Fischer)
In order to receive a video signal on the viewfinder, the VGA port of the viewfinder must be adapted
to DVI. Connect the adapted cable to the "DVI OUT" output of the camera.
The viewfinder should be attached to one of the rosettes.
Additional monitors
A video signal can be fed to additional control and preview monitors in single link mode via the
HD-SDI LINK B (BNC).
When the WEISSCAM DIGIMAG DM-2 is used, the HD-SDI signal can be looped through the
recorder and tapped at the RAW/HD-SDI OUT LINK A and/or LINK B.
"MONITOR OUT" of the camera is currently still identical to RAW Link A.
An onboard monitor can be powered by the internal camera power source. A max. 12V 3A output
is available for this purpose.
