33
2
Functional De
scrip
tion
Quick start guides:
The following sections are intended merely as quick start guides for the respective programs.
For detailed explanations, refer to the corresponding manuals.
WEISSCAMSoftwareforHS-2
IMPORTANT: At the moment only RAW files created by WEISSCAMware can be badge-rendered,
no RAW files copied from DigiMag DM-2 (*.fhgWD). This is planned for the next update.
Start the WEISSCAMware software (camera must be offline)
Load the sequence: In the Settings window, click the "Calibrate/Load Sequence" button to
select the desired sequence. Here, it is sufficient to select a frame of the desired sequence, as
the latter is detected by the WEISSCAMware automatically. Then, click the "Loaded" button to
load the sequence into the timeline.
Carry out the colour correction: Configure the desired values at the left in the Image Control
window using the faders for RGB, saturation, offset etc.
Save the LUT (Look up Table) for these settings via "Save LUT".
Repeat steps 2 - 4 if you want different looks for different material.
Close the WEISSCAMware software (select "Yes" to confirm the safety warning that appears).
Start WEISSCAM Batch Generator.
Using the "Add Batch Job/Take" button, load selected takes into the take field.
In doing so, it is sufficient to select a frame of the sequence, as the latter is detected automati-
cally.
You can display the respective settings by clicking the individual takes.
If you want to change the target folder, you can do so using "Change Target".
The target format can then be set in the "Target Format" line via the drop-down menu. If you
want to render all takes of the take list to the same format, you can configure this by clicking
"Use Selected for All".
To select a new In point or Out point, you have to enable the tick mark behind "Use New Cut
In/Out". Then, enter the new values after "New Cut In Position" and "New Cut Out Position".
For the type of debayering, you can now load the LUT created previously.
To do so, click "Select LUT" in the "CC.:" line and select the corresponding file.
Via "Use Original", you can also use the original settings of the file for rendering.
Now click "Generate Batch File" to generate the corresponding batch file.
Close the batch generator and open WEISSCAMware.
Load the batch render file. In the Settings window, click the "Calibrate/Load Sequence" button
and load the corresponding file.
Confirm the message with OK to start the rendering. A window with the status display of the
rendering process should open.
After the rendering process is finished, you can close the WEISSCAMware software (select
"Yes" to confirm the safety warning that appears).
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
