1
you can only operate the camera in RAW mode.
RAW Link A;B:
In RAW mode, the pure RAW data of the sensor are output via HD-SDI.
Here, HD-SDI serves strictly as the transport stream.
Monitor:
Currently same signal as RAW LINK A.
Hand Unit:
The WEISSCAM Hand Unit HU-2 is connected to this connector.
CamINT:
GigEinterface
- The camera can be connected to a PC System using a con-
ventional Ethernet cable via the gigabit Ethernet interface. All functions of the
camera can thus be controlled via the WEISSCAM software (basic version).
USB-Binterface
, port for loading camera firmware updates as well as
controlling the camera over the WEISSCAM software.
MASTER/SLAVE:
Intelligent master/slave 24V DC IN changeover circuit. It is intended to elimi-
nate any potential image loss due to an unexpected power failure.
– Connect the main power source (power supply unit) to the DC IN 1 (master).
– Connect the spare battery to the DC IN 2 (slave).
If an unexpected voltage drop should occur at the master input, the device
immediately switches to the slave input without impacting camera function.
Once there is sufficient voltage at the master input again, the camera auto-
matically switches back to it.
IMS:
The
I
nterchangeable
M
ount
S
ystem by P+S TECHNIK makes changing cam-
era mounts fast and uncomplicated.
When the camera mounts are changed, the flange back is offset by the mounts.
The following mounts are available from P+S TECHNIK:
PL-Mount
Panavision-Mount
ProfessionalF-Mount
NikonF-Mount
CanonEF-Mount
CanonFD-Mount
BNCR-Mount
Contax-Mount
LeicaM-Mount
–
–
–
–
–
–
–
–
–
