Overhead door 1026, User Manual

Page: 23 / 64

PN# 3642136212, 02/26/2010 REV. 1
23
REMOTE CONTROL
BATTERY REPLACEMENT AND VISOR CLIP INSTALLATION
8
FIG. 8-1 Open battery cover .
1. Battery replacement .
• To open gently push straight out on battery
cover lock tab as shown. (Fig. 8-1) .
• Slide open battery cover.
– Remove old battery.
• Make sure new battery is facing proper direction
(Match battery polarity with symbols inside
battery cover)
(Fig. 8-2) .
– Recommended replacement battery type:
Alkaline A23 , 12 volt.
NOTE: Batteries differ in care and maintenance.
Follow the manufacture’s directions for battery
maintenance, replacement, and use.
• Slip new battery into place.
– Slide battery cover until it clicks shut.
• Operate remote to make sure it is working
properly. (No re-programming is needed.)
2. Visor clip.
(The visor clip may come already installed.)
You will have to install the visor clip if you
choose to attach your remote to the car visor.
• Slide visor clip into back of remote control.
– It will snap into place (Fig. 8-3) .
FIG. 8-3 Attach visor clip .
FIG. 8-2 Match battery polarity .
LIGHT BULB / LENS INSTALLATION
9
FIG. 9-2 Fasten lens .
NOTE: For lens cover locate Box 4.
1. Light bulb .
• Recommendations.
– Do NOT use a short neck bulb.
– Light bulb should be no more than 75 watts.
– Use a
heavy duty service bulb for longer life.
• Screw bulb into socket.
2. Lens .
• Select the white (lamp) cover. Do NOT use the
colored cover in this location.
• Line up lamp lens tabs on power head with
corresponding slots in lens (Fig. 9-1) .
• Slide lens onto power head. Make sure the tabs
are fully engaged into lens slots (Fig. 9-2) .
• Plug power cord back into electrical outlet.
– and + polarity marks
FIG. 9-1 Slide lens onto motor cover .
Lens tabs
Light bulb
Slide out
For added safety and protection please unplug
opener before installing light bulb.
WARNING