Overhead door 1026 User Manual Download

Page: 22 / 64

PN# 3642136212, 02/26/2010 REV. 1

FCC and IC CERTIFIED

FIG. 7-1

Learn code button and LED

SET

OPEN

FORCE

CLOSE

CODE

LEARN

LIMIT

MANUAL

Open

Travel Limit

Open

Set Limit

Button

Travel Limit

Set Limit

Button

Down Force

Control

Adjustment

Up Force

Control

Adjustment

Learn

Code

Button

LED

Indicator Light

Garage Door

This device complies with FCC Part 15 and RSS 210
of Industry Canada. This equipment has been tested
and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause harmful interference to radio or television
reception, which may be determined by turning the
equipment OFF and ON, the user is encouraged to
try to correct the interference by one or more of the
following measures:
• Re-orient or relocate the receiver antenna.
• Increase the separation between the opener

and receiver.

• Connect the opener into an outlet on a circuit

different from that to which the receiver is
connected.

• Consult your local dealer.

PROGRAMMING REMOTE CONTROLS

NOTE: For remote control locate Box 3.

1a. Single Button Remote Programming

NOTE: This opener can learn up to 7 single
button remote controls.

•

Locate "

Learn Code

button and indicator

LED on the power head

(Fig. 7-1)

• Press and release learn code button.

– Indicator LED will blink RED at a rate of twice

per second.

•

Within 30 seconds

, push remote control

button once.
– Indicator LED will stop blinking and stay ON.

• Press remote control button again.

– Red LED will go out. Remote is now programmed

and ready for use.

1b. Multi Button Remote Programming

NOTE: Each button on a multi-button remote is
designed for use with 1 door. You cannot
program 2 buttons to operate the same door, nor
can you program 1 button to operate 2 doors.
You can program a maximum of 7 different
transmitters or wireless devices.
NOTE: Pushing two buttons on power head
simultaneously will erase programmed memory and
limits must be reset.

• For each button

– Program each button separately using the

Single Button Remote Programming steps

2. Operating.

•

Press remote button once.
– Door will move.

• Press button again.

– Door will stop.

• Press button again.

– Door will move in opposite direction.

NOTE: The door will stop automatically at the
fully open or fully closed position.

CODE

LEARN

A moving door can cause serious injury or death.

Keep people clear of opening while door is

moving.

Do NOT allow children to play with opener,

including Wall Button, remote control, or
Wireless Keypad.

During programming, the door opener could

begin to run, so keep people and objects away
from the moving door and its parts. To keep the
door from moving, close the door and
disconnect it from the Opener by pulling the
Emergency Release.

WARNING

LOST OR STOLEN REMOTE

1. Clear memory

• Press and hold "

Learn Code

" button

(on

power head) for 10 seconds or until the red
blinking indicator LED goes out.

• Program remaining or new remote controls as

done previously.

Your door opener will no

longer recognize any signal received from the
missing remote control, or any other which has
not been reprogrammed.