OTT HydroMet SUTRON XLINK 100, Operation & Maintenance Manual

Page: 196 / 248

Page 196 of 248
Command Description
TIME Shows the current system date and time. If followed by a new time,
it changes the system time. E.g. TIME = 2008/12/12 changes the
date. TIME = 10:15:30 changes the time.
TXx [SETUP] [STATUS]
[COUNT] Shows information about the specified transmission.
Setup will show the satellite type and kind for environmental
satellite radios. For other radios, it will have the radio type, e.g.
Iridium
Status gives an idea of what is going on with the transmission.
If there is a transmission in progress, it gives details about it.
If no tx is in progress, last tx results are shown.
If there is no last tx info, next tx time is shown.
If there is no next tx (recording is off), it just shows "Enabled"
Count tells the number of good and bad transmissions made. Right
now, it's the lifetime count. I hope to change it to be the daily count
TXx TXFORM [REPEAT
YYYY/MM/DD
HH:MM:SS] Creates a transmission data buffer along with diagnostic
information.
The REPEAT option along with the time stamp may be used to get
missing data. Please see section
13.3.2.3 R
EPEAT
T
X
D
ATA
>TX1 TXFORM
Tx data would look like this
:BATT 2 #10 11.347 11.423 11.385 11.377 M M :TEMP 2 #10 26.00
25.25 25.75 26.00 M M :BL -1.00 :PWR -1.0/-1.0
Current message is 108 bytes (00:00:04 seconds) out of 2218 bytes
(00:01:00 seconds)
Available space is 2110 bytes
In that message, sensor data is 83 bytes
Worst case SENSOR data (excluding append) is 138 bytes (00:00:05
seconds)
Worst case available space is 2080 bytes
2 meas are active; 2 are marked for tx
>TX1 TXFORM REPEAT
:BATT 2 #10 11.347 11.423 11.385 11.377 M M :TEMP 2 #10 26.00
25.25 25.75 26.00 M M
TXx TXNOW Issue this command to have the system make a transmission as
soon as possible.
VER
Shows the current software version, including build date and time
and the bootloader version.