Page
22
of
248
4.3
Multi-function Button
There is a multi-function button installed on the front.
Briefly pressing this button will turn on the Wi-Fi.
The multi-function button may be used to reboot the unit. If the button is held down for 5
seconds, the red LED will come on. Keep holding the button until the red LED turns off in order to
reboot.
4.4
Status LEDs
The status LEDs give information on how the unit is operating. The LED are multi-colored. The following
table describes the different colors and states of the LED.
Description
Left/Top LED
Right/Bottom LED
Button
Unit is operating
properly
Green blink every 5
seconds
Unit has a Setup
or operating
error
Red blink every 3
seconds
Multi-function
button pressed
Fast flashing blue
Wi-Fi turned on
but no one
connected
Blue blink every 3
sec
Active Wi-Fi
Connection
Solid Blue
Transmitting
Solid Blue
Power Fail
Imminent
Red flash 9Hz
Unit is in Test
mode
Green blink every
second
Red blink every
second
USB Thumb Drive
Operation
Amber blink while
operation is in
progress.
Green LED on solid if
operations complete
successfully.
Red LED on solid if
operations fails.
4.4.1
Power on sequence
When power is applied to the unit, the following light sequence will take place:
Immediately after power on, system software will briefly blink amber and purple LEDs.
As the system completes bootup, it will light up in a colorful sequence
Button, green, blue, amber, purple, amber, green, all off
Summary of Contents for SUTRON XLINK 100
Page 230: ...Page 230 of 248...
Page 247: ...Page 247 of 248...
