OTE Speedport Entry 2i, Maintenance Management Manual

Page: 9 / 99

SJ-20162405182123-002|2016-05-24 (R2.0)
Product Overview
1-3
Figure 1-3 Interfaces and Buttons on the Back Panel
Table 1-3 describes the interfaces and buttons on the back panel of the Speedport Entry
2i.
Table 1-3 Descriptions of the Interfaces and Buttons on the Back Panel
Interface/Button Description
DSL RJ-11 DSL port.
Phone1–Phone2 RJ-11 port, connected to the phone through a telephone cable.
LAN1– LAN4 RJ-45 port, 10/100 Mbps auto MDI/MDIX, used to connect to a PC or
other network device.
Reset
Reset button, used to restore the factory default settings when
pressed for more than 2 seconds in power-ON state.
Power Power jacket, DC 12 V.
1.3.
Hardware Connection
In the following paragraphs, 3 different topologies are described for the connection of Speedport
Entry 2i with a telephone line.
Before you start any connections, pick the telephone plug where you would like to install your
equipment.
1.3.1. PSTN line or Broadband Telephone Line with one voice
channel
If you have a PSTN line (analog telephone line) or a broadband telephone line, connect Speedport
Entry 2i as it is shown in Figure 1-4 below.
Among the components that are contained in the packing box, you may find an additional RJ-11, 1 to
2 ‘Y’ adapter (see point 1 in Figure 1-4 ). The names of the other components are referred in page 4 of
the manual “Equipment Installation Guidelines” which can be accessed in the following Internet
address:
https://www.cosmote.gr/fixed/documents/10280/87751345/quick_speedport_entry2i_16_02_15.pdf