SJ-20162405182123-002|2016-05-24 (R2.0)
Speedport Entry 2i Maintenance Management Guide
1-6
1.3.3.
Broadband telephone line – with the intervention of an
electrician to the internal (home) wiring (e.g. for an
existing ISDN cabling installation)
If you have a broadband telephone line and you already have a cabling installation from the main
telephone plug to the other plugs of your premises for telephony services only (e.g. from a previous
installation of an NT1 to an ISDN line), connect Speedport Entry 2i as it is shown in
(the splitter and the NT1 are not required anymore).
Figure 1-6 Connection of the Speedport Entry 2i to the internal wiring with the intervention of an
electrician.
In case you have a telephone set connected to a telephone plug, you must disconnect it.
1.
Use the
gray
cable to connect the gray port of Speedport Entry 2i with the indication
“DSL”
to the
telephone plug.
2.
You may connect your telephone sets either to the port
“Phone 1”
, or
“Phone 2”
of your
Speedport Entry 2i.
3.
Use the
yellow
ETHERNET cable to connect the ETHERNET port of your computer to one of the first
yellow ports of the Speedport Entry 2i with the indications
LAN1
,
LAN2
or
LAN3
.
The port with the
purple
indication (
STB
) is used exclusively for the connection of the codec which is
required for the OTE TV service.
4.
Connect the power supply adapter to the POWER jacket of Speedport Entry 2i and following,
connect it to the power plug. The LEDs for Power, DSL, Online, Telephony, Service and WLAN will
flash instantly.
You may connect other telephone sets to other plugs, directly (without a filter).
