SJ-20162405182123-002|2016-05-24 (R2.0)
Configure the Management and Diagnosis
6-11
Figure 6-12 Simulation Page
12. Set the parameters. For a description of the parameters, refer to
Table 6-6 Simulation Parameter Descriptions
Parameter
Description
Simulation Type
Simulated service type. Options: PPPoE and IPoE.
Port
Port on the user side that the simulation will use.
VLAN
Specifies whether to carry a VLAN tag in the packets sent over the WAN
connection. By default, this check box is not selected. If it is selected, a
VLAN tag is carried in the packets sent over the WAN connection, and the
VLAN ID
and
802.1p
parameters must be set.
VLAN ID.
Identifies a VLAN. Range: 1–4094.
To ensure normal service operation, the VLAN ID must be the same as
that set in by the network service provider who will inform the user
about the value of the VLAN ID field.
802.1p
If VLAN is enabled, you can modify service priority through this parameter.
Range: 0–7. A higher number indicates a higher priority.
Username
Username of the PPPoE account. The username must be the same as that
set on the peer server for authentication.
Password
Password of the PPPoE account. The Password must be the same as that
set on the peer server for authentication.
