Zone
Zone
MODULAR SYSTEM MANAGER SD
VCB-X Operator Interface SD
16
System Manager SD Keys and Buttons
Operator Interfaces
In order to con
fi
gure and program the Orion System controllers, you
must have an Operator’s Interface or a personal computer with the Prism
2 computer front-end software installed. Three different Operator Inter-
faces are available for programming of the Orion Controls System—the
Modular Service Tool SD, the Modular System Manager SD, and/or the
System Manager TS II. These devices allow you to access the status and
setpoints of the controllers on your communications loop. This manual
describes the Modular System Manager SD. If using the Modular Service
Tool SD, please see the
Modular Service Tool SD Quick Start Guide
. If
using the System Manager TS II, please see the
System Manager TS II
Technical Guide
. If using Prism 2, please see the
Prism 2 Technical Guide
.
The Modular System Manager SD allows you to view any input or output
status and change any setpoint to
fi
ne-tune the operations of the total
system. All keypad operations are simple and straightforward, utilizing
non-cryptic plain English messages.
Display Screens & Data Entry Keys
See the chart below for a list of the keypad descriptions and functions.
Keypad
Description
Key Function
Modular System Manager SD
ESC
Use this key to exit from screens or from data
entry or to return to the Main Screen from
any screen in the system.
ENTER
Use this key to enter a new value.
Clear
If a data entry mistake is made, press this key
to clear the data entry
fi
eld and start over.
Minus
If a setpoint with a negative value is required,
press this key for the minus sign.
DEC
Press this key when entering data that re-
quires a decimal point.
Use these keys to change values in the Con-
fi
guration Screens as prompted.
Use these keys to step backward or forward
through the screens.
Mode Selection Buttons
The Modular System Manager is provided with “Mode Selection But-
tons.” These buttons give you instant access to the speci
fi
c mode desired
without having to scroll through several menu screens to get there.
Button
Description
Modular System Manager SD
STATUS
Pressing this button takes you directly to
the controller “Status” screens.
SETPOINTS
Pressing this button takes you directly to
the controller “Setpoints” screens and
“Con
fi
guration” menu.
SCHEDULES
Pressing this button takes you directly to
the controller “Schedules” screens.
OVERRIDES
Pressing this button takes you directly to
the controller “Overrides” screen. See the
“Override Button” section on
page 21
for a
description of this function.
See Notes 1 & 2 below.
ALARMS
Pressing this button takes you directly to
the controller “Alarms” screen. See the
“Alarms Button” section on
page 20
for a
description of this function.
See Notes 1 & 2 below.
Notes:
(1) This button only functions when the system is con
fi
gured for
“Network Mode” or “Multiple MGRS Mode.” It will not function
in “Stand Alone Mode.”
(2) The “Search for Units” function must be performed on the
System Manager upon initial system setup before this function
will be available. See the “Network Mode & Multiple Managers
Loop Search” on
page 20
of this manual for complete instructions
on performing a loop search.
Table 3: Keypad Descriptions
Table 4: Button Descriptions
