VCB-X Operator Interface SD
APPENDIX A - SAVE, LOAD, COPY SETPOINTS
81
Copy Setpoints - Network Mode
To copy a saved setpoints
fi
le to other controllers on the network do
the following:
From the
Save Setpoints Screen
shown below:
Save Setpoints
Press Enter To Save
Press
<
>
once to access the
Copy Setpoints Screen
shown below.
Copy Setpoints
From Loop 1
From Unit 2
Press Enter to Copy
In the ‘From Loop’
fi
eld, enter the Loop of the controller you want to
copy the setpoints from. In this example it is ‘1’. Then
press
<ENTER>
.
In the ‘From Unit’
fi
eld, enter the Unit ID of the controller you want to
copy the setpoints from. In this example it is ‘2’. Then
press
<ENTER>
.
Now your cursor will be on the last line, and you can
press
<ENTER>
once more to copy the setpoint
fi
le from unit 102 to unit 103.
You will receive a con
fi
rmation that the copy was successful.
Save & Copy Setpoints - Stand-Alone
Mode
The instructions for Stand-Alone Mode are exactly the same as Network
Mode, except that there is no need to enter a Loop number in the Unit
ID number
fi
eld and in the
Copy Setpoints Screen
, enter a zero in the
‘From Loop’
fi
eld.
Restore Setpoints - Network or
Stand-Alone Mode
The Restore Setpoints feature is used to reload a saved setpoints
fi
le
from one controller back to itself. This could be useful if setpoints or
con
fi
gurations were changed and need to be reset.
You can perform this function on a networked system; however, the
Modular Service Tool needs to be directly connected to the controller
you wish to restore previously saved setpoints to.
From the
Save Setpoints Screen
shown below:
Save Setpoints
Press Enter To Save
Press
<
>
four times to access the
Restore Setpoints Screen
shown
below.
Restore Setpoints
Press Enter to Load
Press
<ENTER>
. This will reload the setpoints from the saved
fi
le. You
will receive con
fi
rmation that the setpoints were loaded successfully.
Copying & Restoring Previously Saved Setpoints
