Orchid SoundWave 32, User Manual

Page: 41 / 75

Section 3: Technical Help and Information
SoundWave 32 User's Manual 39
2. If the lock up occurs when loading the SW32.EXE
file, disable all sound settings by using SW32 /C.
Enable each sound setting one at a time to identify
which setting is causing the lock up. Port ad-
dresses and DMA conflicts will normally cause a
lock up. IRQ conflicts will cause continuous noise
from the speakers. When you have identified the
conflict, change the address setting.
3. Check whether another peripheral in your system
is using the same I/O address configured by
Jumper J3 on the SoundWave 32.
Symptom 2
No startup sounds when running the SW32.EXE
program.
Check
1. Verify that the external speaker is properly con-
nected to the SoundWave 32 stereo speaker jack.
2. Verify that the Startup Music is on and the volume
is turned up in the SW32.EXE program.
3. Since the SoundWave 32 uses the SoundBlaster
interface to play the Startup Music, check for
possible conflicts with the SoundBlaster interface
settings.
4. Verify that the ORCHID.WAV file is in the SW32
directory. This file is limited to 8-bit resolution
and 22KHz sample frequency (mono). If you
have replaced the ORCHID.WAV file with an-
other wave file, verify that it does not exceed these
limits.
Symptom 3
I cannot access the CD-ROM drive.