Orchid SoundWave 32, User Manual, Page: 35 / 75

SoundWave 32 User's Manual 33
Section 2: Software Installation
Changing the Address Settings
If you need to change the SoundWave configuration
or change the address settings due to conflicts, run
the SW32 /C program from the DOS command line.
For help on eliminating address conflicts, see "Avoid-
ing Address Conflicts" in Section 3.
SW32.EXE Utility
The SW32.EXE utility program adds a device driver
line in your CONFIG.SYS file that includes the ad-
dress settings and emulation modes of your
SoundWave 32. You have the option of changing the
hardware settings and the operating mode of the
SoundWave 32 from the DOS command line.
For example, to change the hardware setup values
from the SW32 subdirectory, type the following:
C:\SW32 /C
The command line options are as follows:
/? - A listing of options and syntax
/C - To change the hardware setup values
/S - Check the status of the current configuration
/V:x - Sets the volume, where x is 0 to 31
SW32 - To set the hardware configuration