Orchid SoundWave 32, User Manual

Page: 14 / 75

Section 1: Installing SoundWave 32
12 SoundWave 32 User's Manual
Jumper J3: I/O Address
Jumper J3 sets the base port address for Sound Blaster
mode. The default setting is 220 Hex.
For help on
avoiding
address
conflicts, see
Section 3.
Jumper JP1: Wavetable
There are two 512K Wavetable ROM chips on the
SoundWave 32, which stores 2MB of compressed
sample sounds. The DSP on the card decompresses
the sample sounds when it plays them.
The default setting of 512K gives you 2MB of authen-
tic instrument recordings. The 1MB setting is for the
optional 4MB of sample sounds. Refer to Table 1.2.
Figure 1.2: Jumper J3 (pins 2 and
3 connected).
Default address
1 2 3
If you need to change the default address, connect pins 1 and
2 to select the optional address—240 Hex.
Figure 1.3: Jumper JP1 (pins 2
and 3 connected).
Default
address
1 2 3
To configure for the optional 4MB of sample sounds, connect
pins 1 and 2 to select the 1MB address setting.